919RickR
05-19-2018, 06:07 PM
Hello all, I am selling my lightly used 2007, 96x48 PRS Standard Shopbot.
It comes with;
computer and SB software
6 zone vacuum table with a 4 motor vacuum box 220v
vacuum gage
center legs added
3hp spindle/ 220v single phase with converter
Original 3.5hp PC router
Shopbot probe (used twice)
Donek drag knife
pneumatic clamps
pneumatic misting system (air or liquid coolant) with regulator
extra 8020 aluminum rails (1 1/2 x 3) down the sides for clamping
misc clamps, bits, collets.
I have run the machine on one large 3D project for 36 continuous hours without any problems.
A little dusty but runs flawlessly, I hate to see this wonderful
machine sit there. It needs to be working. This is a great machine.
I wish I had more work to keep it busy
I am asking $11,000 neg
Thanks for looking
Rick
Could only add 5 pics. message me and add email if you need more info
It comes with;
computer and SB software
6 zone vacuum table with a 4 motor vacuum box 220v
vacuum gage
center legs added
3hp spindle/ 220v single phase with converter
Original 3.5hp PC router
Shopbot probe (used twice)
Donek drag knife
pneumatic clamps
pneumatic misting system (air or liquid coolant) with regulator
extra 8020 aluminum rails (1 1/2 x 3) down the sides for clamping
misc clamps, bits, collets.
I have run the machine on one large 3D project for 36 continuous hours without any problems.
A little dusty but runs flawlessly, I hate to see this wonderful
machine sit there. It needs to be working. This is a great machine.
I wish I had more work to keep it busy
I am asking $11,000 neg
Thanks for looking
Rick
Could only add 5 pics. message me and add email if you need more info