Sea Dek

[ccwerks]

Has anyone cut this stuff?
I think its two bit process .250 end mill and a v bit to finish.
Just looking others experiences.

Thanks
Mark

[khaos]

There has been a mix. It cut like butter for me but for Mark D. it was a nightmare with chipping and horrible cuts. We used basically the same bits and feed and speeds. I know "Sometimes its good" is not what you wanted to hear. But forwarned and all that.

[ccwerks]

what feed and speed are you using?

[khaos]

I used a 2 flute endmill 4in/sec @ 13K .125 passes

[ccwerks]

thank you sir.
Ill give it a run.