groovinjello
01-22-2010, 12:20 AM
Ok, I'm using a "community" shopbot and tried to run Bill Young's "Workstation" patter that I downloaded from ShopBot Project Wizard (http://www.shopbotprojectwizard.com/pw/products.aspx?product=7&id=7)
When doing an air cut, the ShopBot started jerking and shaking (I don't know how else to describe it). Someone there said I had the project feed speed to high.
My concern is that:
1. this file was created by a well known ShopBotter who I would trust to have a speed set for general use.
2. only the sbp files were provided so I don't know how to adjust the feed speed or make any further adjustments to the project (if anyone knows how to get ahold of the dxf or vector file of the workstation project, I would be grateful).
I'm worried that there might be something wrong with the shopbot I'm using and I should notify the people who own it.
Thanks for any help!
Nate
When doing an air cut, the ShopBot started jerking and shaking (I don't know how else to describe it). Someone there said I had the project feed speed to high.
My concern is that:
1. this file was created by a well known ShopBotter who I would trust to have a speed set for general use.
2. only the sbp files were provided so I don't know how to adjust the feed speed or make any further adjustments to the project (if anyone knows how to get ahold of the dxf or vector file of the workstation project, I would be grateful).
I'm worried that there might be something wrong with the shopbot I'm using and I should notify the people who own it.
Thanks for any help!
Nate