TJ
07-29-2018, 01:48 PM
3185531856
Hello everyone,
Please join ShopBot Tools this Tuesday July 31st, 2018 for a free online training. The topic this week is “Two Sided 3D Machining” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will work through the setup and machining of a 3D model. This model will need to be machined from two sides so we will look at techniques for layout in the design software as well as alignment options on the ShopBot for flipping the board over. We will also talk about zero plane positioning, overcutting, tabs and dowels for hold down.
There is no need to sign up, just show up a few minutes early on Tuesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email.
This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
Two Sided 3D Machining
Tue, Jul 31, 2018 1:00 PM - 3:00 PM EDT
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/784697413
You can also dial in using your phone.
United States: +1 (571) 317-3112
Access Code: 784-697-413
Joining from a video-conferencing room or system?
Dial: 67.217.95.2##784697413
Cisco devices: 784697413@67.217.95.2
First GoToMeeting? Let's do a quick system check:https://link.gotomeeting.com/system-check
Hello everyone,
Please join ShopBot Tools this Tuesday July 31st, 2018 for a free online training. The topic this week is “Two Sided 3D Machining” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.
Using a ShopBot and the Vectric software this training will work through the setup and machining of a 3D model. This model will need to be machined from two sides so we will look at techniques for layout in the design software as well as alignment options on the ShopBot for flipping the board over. We will also talk about zero plane positioning, overcutting, tabs and dowels for hold down.
There is no need to sign up, just show up a few minutes early on Tuesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.
If you have any other questions please feel free to shoot me an Email.
This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.
Thanks and hope to see you there. Thanks, TJ
Two Sided 3D Machining
Tue, Jul 31, 2018 1:00 PM - 3:00 PM EDT
Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/784697413
You can also dial in using your phone.
United States: +1 (571) 317-3112
Access Code: 784-697-413
Joining from a video-conferencing room or system?
Dial: 67.217.95.2##784697413
Cisco devices: 784697413@67.217.95.2
First GoToMeeting? Let's do a quick system check:https://link.gotomeeting.com/system-check