Nesting

[jimmya]

I am using Aspire 9.5 and am trying to Nest Letters and getting letters on top of each other. What am I doing wrong? See Attachment
http://www.talkshopbot.com/forum/attachment.php?attachmentid=32072&stc=1
Thanks for your help
Jimmy

[jimmya]

If needed I can post the file.

Jimmy

[jimmya]

Here is the file

32073

[scottp55]

Possible to "save as" a .crv?
Aspire file can't be opened by a lot of us:(
Thanks
scott
UNLESS they're 3D letters. But doesn't look like it. 2.5D won't affect nesting.

[srwtlc]

The KE and RS in both Dickerson's are slightly overlapped. Nudge them apart a bit and it will work.

[jimmya]

CRV File

32075

[scottp55]

Thanks for the .crv Jimmy.
Unfortunately I'm using Shopbot Edition VCP9, and patiently waiting for the VCP9.5*** upgrade, which isn't out yet.
Trust the other Scott!! :) :)
scott

[jerry_stanek]

I was getting the exact same thing when I tried that CRV until I split the letters that were over lapping.

[jimmya]

Thank you all for responding. I did move the letters where they didn't touch each other, and the nesting worked. But I can’t see why it would stack on top of each other.
Thanks you for your Help
Jimmy

[jerry_stanek]

I think that Aspire thinks it is ok to put those letters on top of one another

[knight_toolworks]

nesting has always been a bit strange when parts overlap. it used to not work at all. that made things a pain. like when you had parts with dados and such.