View Full Version : Converting Part Works File.crv to .sbp file
huntfairchase
01-17-2010, 12:37 PM
I was trying to run files I created in PW V2 which have a .crv extention. The control software does not reconize them. What are the steps to convert a Park Works File into a .sbp file that the control software reconizes?
thewoodcrafter
01-17-2010, 12:49 PM
You need to generate and save a tool path file.
On the upper right side of the PartWorks screen is where you do this.
You need to highlight the area of your work you are going to tool path then select the tab on the upper right of the screen.
There you can pick what type of tool path you are going to make, select the tool, set the depth, speed, etc.
I am sure Vectric has a video of how to do this on there site.
huntfairchase
01-17-2010, 04:54 PM
I have made all the tool paths but the file extention remains .crv which the control software won't reconize. I need to figure out how to convert to .sbp file. No option to save the file in that format exists that I can find.
thewoodcrafter
01-17-2010, 05:19 PM
Under the tab to the upper right is an icon to save.
Have you saved it under this tab or under the save icon on the left?
You are saving the TOOL PATH not the file (.CRV) with the save icon under this tab.
coach
01-17-2010, 05:29 PM
Mike, when you save and it shows .crv
backspace the .crv away and then add in .sbp
I do that sometimes.
coach
01-17-2010, 05:31 PM
On second thought , if something is wrong with your software this may not be the right solution for you.
coach
01-17-2010, 05:36 PM
looking at partworks, are you clicking the icon
that states "save toolpath" in the toolpath side?Have you set up the correct post processor?
knight_toolworks
01-18-2010, 01:20 AM
here is where you need to visit.
http://www.vectric.com/WebSite/Vectric/support/vcpro_tutorials.htm
billh
05-05-2014, 01:13 AM
Hello all.
New guy here.
Ive tried saving all file types but I cant get part works to save as a sent file. When I "save" in the tool path area I get an "invalid argument was encountered" prompt.
Its very frustrating as all im trying to start with is a simple circle.
I just bought this machine if there is anyone whom might assist I would be most happy.
Ill also contact vetric to see if they can help.
Im not sure where to even start.
Bill
jerry_stanek
05-05-2014, 06:58 AM
Have you gone to the vectric site and watched the first cut 2D video it will show you the steps to take
Ken Sully
05-05-2014, 07:50 AM
Jerry,
Check this out. When you pick the output make sure it is shopbot. The sbp extension
http://www.vectric.org/video/aspire4-vcp7/getting-started/A01s/A01s-w.html
srwtlc
05-05-2014, 09:39 AM
William, are you attempting to 'Output direct to machine'?
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.