New Project

[jwa1156]

I am attempting to make a sleeve/holder for a metal tumbler.
Though I could cut the sleeve on my Desktop in halves and them glue them together.
If I can do it on the Shopbot the fitting could be much better than on a lathe.
But I can't figure out if it is possible.
Have attached a Aspire drawing to show the idea.

Thanks for any ideas
32307

[phil_o]

This video should help. https://www.youtube.com/watch?v=xN4S3LgmrMM

Phil

[jwa1156]

3230832308
Worked like a charm
Hope the picture attached correctly

[phil_o]

It's a great tool, very easy to use, versatile.

Phil

[knight_toolworks]

it would have even been easier to cut these out of stock with just a hole in the center and the outside what you want and stack them together with glue. though the grain may not work for you but it makes the operation easy and fast.