jeffreymcgrew
03-27-2007, 07:40 PM
Hey all. Really weird problem cropped up the other day with my z-plate.
It was working fine for a while, but about three days ago it suddenly thinks that my router is part of the circut. I mean that if I take the clamp and plate off the holder, and touch them I can watch the light on the control panel turn on and off just like it should, but then if I touch the clamp to the bit or the router body it, too, makes the light trigger. Which has me a bit concerned, for it very much sounds like a short someplace. I've looked at all the Z-plate wires and can't find any problems at all. They look good. Could something else be putting a slight charge into my Shopbot frame that's triggering the z-plate? Anyone run into something like this before?
It was working fine for a while, but about three days ago it suddenly thinks that my router is part of the circut. I mean that if I take the clamp and plate off the holder, and touch them I can watch the light on the control panel turn on and off just like it should, but then if I touch the clamp to the bit or the router body it, too, makes the light trigger. Which has me a bit concerned, for it very much sounds like a short someplace. I've looked at all the Z-plate wires and can't find any problems at all. They look good. Could something else be putting a slight charge into my Shopbot frame that's triggering the z-plate? Anyone run into something like this before?