PRS96 with 4G and ATC for sale

[Jason Chapman]

Hello

This shopbot was originally used is a cabinet making shop. We acquired the shopbot in 2005. The shopbot has been used to mill parts from 4x8 sheets of expanded PVC and marine plastic. Milling is set at 2 ips for 1/4" cutter and jogging speed is set at 3 ips.
The shopbot has many hours on it and has been well maintained. We are retiring so we are selling our equipment.


We are in Portland Oregon. Full onsite or face time demo available.
We are asking $7500 for the shopbot and all the support equipment show below. There are 20 tool holders included. The buyer is responsible for disassembly and transportation.

Thank you
Jerry Chapman 503-860-7890

UPGRADES/General information:
Welded carriage,
Pneumatic material lifting plugs,
and Prox Sensors
33322

Steel rails,
Stepper motors held in place with pneumatic cylinders,
and Spindle weight offset by a pneumatic cylinder
33325

Fifteen tool Automatic Tool Changer (ATC). Five of the fifteen shown below,
Z-height reference for the tools in the ATC,
and Z-height reference to table height.
33323
33324

Dust Collector and Vacuum
33326

[srwtlc]

Might be good to have a picture of the whole machine. This is not a PRS, but looks to be a highly modified PR.

[Jason Chapman]

Scott
Thank you for the catch. It is a PR96 and not a PRS96.
http://www.talkshopbot.com/forum/attachment.php?attachmentid=33332&stc=1

http://www.talkshopbot.com/forum/attachment.php?attachmentid=33333&stc=1

[Jason Chapman]

This is a PR96 with the upgraded rails. This is a OBO.
Thank you