Captive
11-24-2019, 10:39 PM
PRS Air Drill Head Double Valve R2
This unit has only about 10 hours of running time on it.
Shortly after purchasing my PRS Alpha Shopbot in 2016 I move from one shop to another and did not end up reinstalling the Drill Head as I don't really use it all that much.
Its pretty much been on a shelf since
This item is virtually new as I mentioned it has seen very limited use.
Item is located in Leduc, Alberta Canada.
When I purchased this cost was $1750 USD but I am open to a reasonable offer.
I can be reached via email captivecutting@yahoo.com
Or cell 1 780 686 9727
I can also send more photos via email if you like
Mark Jakabek
www.captivecutting.com
@captivecutting
This unit has only about 10 hours of running time on it.
Shortly after purchasing my PRS Alpha Shopbot in 2016 I move from one shop to another and did not end up reinstalling the Drill Head as I don't really use it all that much.
Its pretty much been on a shelf since
This item is virtually new as I mentioned it has seen very limited use.
Item is located in Leduc, Alberta Canada.
When I purchased this cost was $1750 USD but I am open to a reasonable offer.
I can be reached via email captivecutting@yahoo.com
Or cell 1 780 686 9727
I can also send more photos via email if you like
Mark Jakabek
www.captivecutting.com
@captivecutting