Z zero plate for PR

[jerry_stanek]

I picked up a used PR and it has a z zero plate installed. What I would like to know is how to use this plate with the older dos version of the shopbot software.

[Brady Watson]

It's the same as the new software pretty much, except where the files are located on your computer. There is a small difference in how the Zzero routine works. Make sure that the the SB200 folder is installed on the root of C (C:\SB200\) and that the 2 files in the attached ZIP are there. Edit S_Zzero.sbp at the line where it asks you for the thickness of your plate. Then just run C2 and you should be in business.

-B

SB200_Zzero.zip (http://www.talkshopbot.com/forum/messages/26/SB200_Zzero-28422.zip) (2.1 k)