First time tiling on Desktop

[Mike Caul]

I think I know the answer, but I want to reassure myself. I'll be tiling in the "y" axis with 3 tiles. I will be using 3 different bits on the project. Do I make all of the cuts on each tile? Pocket, V-Carve and profile on T1 then move my material and do the same on T2, then T3? Thanks in advance.

[scottp55]

It's more time consuming with the changes of the bits, BUT less chance of a screwup too.
That's the way I would do it.
I'd definitely skim spoilboard first, and make Very sure the material is firmly Flat against spoilboard each time I moved material accurately.

[Mike Caul]

It's more time consuming with the changes of the bits, BUT less chance of a screwup too.
That's the way I would do it.
I'd definitely skim spoilboard first, and make Very sure the material is firmly Flat against spoilboard each time I moved material accurately.

Thanks Scott,
I just surfaced my spoilboard and using a roller stand. I also plan to use indexing dowels.

[scottp55]

Then you're good to go Mike:)
I was nervous as heck both the first And second time:)
scott