kulpcm
09-14-2020, 05:09 PM
I have to make room in my garage, so I'm selling the ShopBot Buddy:
I have had it for about 3 years, bought it off of a violin/guitar maker in NH. Used it about 20-30 hours since then. Been great for signs and the other things I have been working on. In great shape.
Just does not get as much time in use as my shopbot desktop.
Believe it is a 2008-2010 vintage, and the Shopbot tech team confirmed its the current board and controller card.
34115
34116
-Porter Cable 7518 router
-1/2" collets
-3D digitizing probe
-Dust Foot
-Including license to Vectric PartWorks
- Caster wheels
- Laptop that came with it (not what I use)
Pick up only. Located outside of Philadelphia, PA near Villanova. I do not have a means to deliver or ramps, but it can wheel right out of the garage into the driveway.
$7000 - half of a new one.
I have had it for about 3 years, bought it off of a violin/guitar maker in NH. Used it about 20-30 hours since then. Been great for signs and the other things I have been working on. In great shape.
Just does not get as much time in use as my shopbot desktop.
Believe it is a 2008-2010 vintage, and the Shopbot tech team confirmed its the current board and controller card.
34115
34116
-Porter Cable 7518 router
-1/2" collets
-3D digitizing probe
-Dust Foot
-Including license to Vectric PartWorks
- Caster wheels
- Laptop that came with it (not what I use)
Pick up only. Located outside of Philadelphia, PA near Villanova. I do not have a means to deliver or ramps, but it can wheel right out of the garage into the driveway.
$7000 - half of a new one.