X axis backwards

[ljdm]

Just rewired, etc.... Y axis ok, Z ok. X axis runs in minus values up the table. Switched plugs on control box, same thing. Green and black reversed on one of the plugs. Preview mode shows home where it should be.

[pfulghum]

You can trick it to run the other way by using a negative unit value. Just use the same unit value, but put a "-" in front.

-- pat

[ljdm]

Was going to do that, kind of wanted to figure what is causing it to happen though.

[Brady Watson]

Reverse the green & black wires in either end of the Wago connector on EACH X axis. Make sure control box is OFF.

-B