PRTalpha 96-60 5' x 8' x 12" Cutting area / Z Axis Height

[Bob.Sharon2008]

I have a used PRTalpha that was purchased at auction from an old employer at auction. I had the intentions of hooking it up in the barn for a side business of doing HDPE signs. As of right now, I don't have the time to invest in it. Currently not fully assembled.

I have all the manuals and some spare motors/parts, etc... for it. (pictures of when it was assembled and original invoice attached)

It's been a while since it was used. Would be sold AS-IS.

Located in the Frankfort, KY area. Looking for $8,000 OBO for it. Buyer would be required to come pick it up / transportation.

Depending on responses I may consider parting it out as well.

[Bob.Sharon2008]

Here are some additional pictures of the spare parts (Motor, Board), Manual and computer. 3464134642

I would really like to get this moved, so let me know your thoughts on an offer. I'm open.

[Bob.Sharon2008]

Lowered to $4,000.

[Bob.Sharon2008]

All,
I need this out of my barn, no decent offer refused.

[RobbyFirstBuild]

I live in Louisville. I could do $3k if you are interested.

[Bob.Sharon2008]

Let's talk. Sent a private message

[Bob.Sharon2008]

Sold and picked up over the weekend.

Thanks RobbyFirstBuild! Hope you made it back to L'ville Safely.

[RobbyFirstBuild]

Yes sir I did, got it unloaded with no damage and nobody killed, success!

[HCW1980]

Is this still available?

[RobbyFirstBuild]

No, I bought it about a month ago.
Robby