johnm
11-26-2005, 01:05 PM
Folks -
Well, We've got a sticky wicket... I can't start the spindle, except in keypad, and I get an error message when I run the SB setup routine. It just says that there was a problem and to run it again. SB *has* apparently picked up some of the useless "help" dialog boxes from Microsoft... Tell you something is worng, but not WHAT is worng and how to fix it...
Okay, If I insert SO 1,1 in a file before MS in the edit mode, and then SO, 1,0 at the end, it works, but how do I modify the spindle speed?
Also, in keypad, how do I change the spindle speed for proper warm up?
Halp!
John Moorhead
Well, We've got a sticky wicket... I can't start the spindle, except in keypad, and I get an error message when I run the SB setup routine. It just says that there was a problem and to run it again. SB *has* apparently picked up some of the useless "help" dialog boxes from Microsoft... Tell you something is worng, but not WHAT is worng and how to fix it...
Okay, If I insert SO 1,1 in a file before MS in the edit mode, and then SO, 1,0 at the end, it works, but how do I modify the spindle speed?
Also, in keypad, how do I change the spindle speed for proper warm up?
Halp!
John Moorhead