Vers 3.5.5 keypad problem

[dingenis]

I upgraded to vers 3.5.5
reinstalled firmware,seems to be ok ,exept that i dont see a board number (prt 4g)
files seems to be running ok but keypad behaves weird
>> moving, or jogging the tool in keypad mode : the tool start moving extremely slow, and ramps up very, very slow not even reaching full speed.
I tried changing VR for keypad but problem still remained.
when running files moves and jogs are ok.
I am running METRIC files MM

when the machine is set to INCHES keypad speeds are ok
I have contacted support,
will post when there is an answer,
grt
dingenis


,

[hespj]

As a mm user I've got the same problem.

[dingenis]

hi,
there is a new version release, 3.5.6
it says problems with keypad in mm resolved.?
have not yet installed, will post later this day
gr
dingenis.

[dingenis]

hi,

just installed vers3.5.6
controlbox firmware installed,
keypad is working ok in MM.
(have not run files , just a made a quick check)

grt
dingenis

[hespj]

Hurrah!!

[dingenis]

hi john,
working in the UK and using MM?
just run some part files and all seems ok.