mikejohn
11-04-2005, 12:40 PM
Today I cut a file,profile V-carving the detail in a 2D Santa, I guess like yard art, but this is for a shop window display.
It was short and fat, I wanted it taller (and bigger overall)
I scaled up my 'x' by 1.3, m 'y' by a factor of 2, left Z untouched
Most of it worked fine, but a couple of lines extended themselves beyond there position (relative to other lines) that they were in in the original cut.
Anyone else experienced problems scaling up?
.....................Mike
It was short and fat, I wanted it taller (and bigger overall)
I scaled up my 'x' by 1.3, m 'y' by a factor of 2, left Z untouched
Most of it worked fine, but a couple of lines extended themselves beyond there position (relative to other lines) that they were in in the original cut.
Anyone else experienced problems scaling up?
.....................Mike