paul60
09-08-2008, 04:42 PM
after i zero at the corner of the table, i then move
the router out. lets say 3 feet out on the table.
when i hit jh on the key board the router would move no more that about 14 inches then stop.
i own a prt standard 48x96.
control software 3.4.19.
the software was reinstalled .
thanks paul
the router out. lets say 3 feet out on the table.
when i hit jh on the key board the router would move no more that about 14 inches then stop.
i own a prt standard 48x96.
control software 3.4.19.
the software was reinstalled .
thanks paul