bstern
07-05-2007, 11:22 AM
I know this topic has come up before but I have not seen a definitive answer.
After completing assembly of my PRS Alpha my X car was out of square by quite a bit. I have used the method of pulling the car to the pre set stops and hitting the reset button. Works fine.
Has anyone written software to move one X car motor independently? Is it even possible?
It would be great to incorporate the compensation into the C3 command.
I have concerns about moving my X car 3 or 4 inches manually each day. This could eventually lead to damage of controller.
After completing assembly of my PRS Alpha my X car was out of square by quite a bit. I have used the method of pulling the car to the pre set stops and hitting the reset button. Works fine.
Has anyone written software to move one X car motor independently? Is it even possible?
It would be great to incorporate the compensation into the C3 command.
I have concerns about moving my X car 3 or 4 inches manually each day. This could eventually lead to damage of controller.