View Full Version : CASmate Pro 6.52
bolander
08-10-2006, 11:48 AM
My plotter will not complete the entire cut when using CASmate Pro. I have loaded CASmate on my other two systems and it does the same thing. Thus eliminating a plotter problem. Any suggestions?
kerrazy
08-10-2006, 01:20 PM
Expand please?
bolander
08-11-2006, 03:29 PM
Hi Dale..
When I send a job to the plotter using CASmate Pro, it only cuts 97% of the job. It doesn't matter if the file is large or small. I have:
1. New HASP plug from Scanvec.
2. New USB cable.
3. Replaced LPT1 port (new)
4. De-installed/re-installed CASmate
5. Tried reconfiguring set-up to different types of plotters.
Just can't figure it out! CASmate worked fine. Just one day it quit finishing the plot. I can see if I had changed systems or plotters, but I haven't. Go figure?
Hope this gives you something more to work with.
Thank you for your time... Roger
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.