Beginner guy (Unregistered Guest)
09-20-2005, 08:52 PM
Hello Folks,
I just got my PRT running yesterday. I adjusted the VU values to work with the regular PRT gears. The problem is that all my move (M) commands work fine. MX 5 will move the X carriage exactly 5". However, my jog feature doesn't work correctly. JX 5 moves the carriage very slowly about 1/2 an inch. My move and jog spees are both set to 2in/s for X/Y and 1in/s for Z. Any ideas what's happening? Thanks.
I just got my PRT running yesterday. I adjusted the VU values to work with the regular PRT gears. The problem is that all my move (M) commands work fine. MX 5 will move the X carriage exactly 5". However, my jog feature doesn't work correctly. JX 5 moves the carriage very slowly about 1/2 an inch. My move and jog spees are both set to 2in/s for X/Y and 1in/s for Z. Any ideas what's happening? Thanks.