gg1
05-23-2007, 08:40 PM
I have a question
What can I do to stop this!
If I am in the middle of a cut and want to change the feed rate I have to hit the S key shut down the machine and go back to the last line number, reset the toggle on the output and start at that point.
The spindle stops.
Can this be bypassed?
We have two machines and the old one running old software don't require me to do this.
I hope I am not as dumb as a box of rocks asking this!
Thanks Leonard
What can I do to stop this!
If I am in the middle of a cut and want to change the feed rate I have to hit the S key shut down the machine and go back to the last line number, reset the toggle on the output and start at that point.
The spindle stops.
Can this be bypassed?
We have two machines and the old one running old software don't require me to do this.
I hope I am not as dumb as a box of rocks asking this!
Thanks Leonard