DeskProto Working Post Processor?

[Brady Watson]

Hey all,
I just downloaded DeskProto 3.1. I can't seem to get the Fanuc Inch or G-Code to SBP post processors to create a usable part file.

When I use the G-code convertor in DOS & preview in SB Windows V3 Preview, it only shows X, Y moves...Unlike when I use MillWizard for a 3D file and preview it and I actually see the 3D file before it cuts.

Has anyone managed to get DP 3.1 to work on their Bot? Any help is greatly appreciated.

Thanks!
Brady

[Ryan Patterson (Unregistered Guest)]

Brady
I Use deskProto 3.0. The post processors i use is in the list(Shopbot using G Code Conversion cnc2sbp) I convert the G Code in sb's dos ver. the windows ver. does not convert. I have never used the preview for 3D.

Hope this helps,
Ryan

[Brady Watson]

Thanks Ryan. I tried the cnc2sbp, but it didn't seem to work. I'll have to try it again. I did have some success with the Generic G-Code Plain Inch driver and converted it with the SB converter.