Shopbot post processor for Freemill

[paulkiecka]

today I downloaded freemill and it looks very promising. after reading older archived posts it appeared I needed a post processor for Shopbot as the Fanuc choices in the program would not work. I went to the site
http://www.mecsoft.com/Mec/Downloads/posts.shtml

and although there where links to "shopbot" and "shopbotgcode" both of them where dead saying "Not Found"

As all the post were at least 3 years old I was wondering if something changed since then and there is another solution.

thanks,
Paul

[paulkiecka]

I left a message on the mechsoft forum and they made the files available. (there's a link in their post if anyone else needs/wants them.

http://www.mecsoft.com/phpbb/viewtopic.php?p=6656#6656

[paulkiecka]

As of this moment the zip file referenced above does not contain the needed files. although at first glance there are files with the correct filename, those files contain messages that the url was not found. So, I sent another message and am hoping for the best. Anyone here have those files?

[paulkiecka]

no longer need help. found ShopBot's page that had the download for VisualMill 3.0 and 4.0 post-processors.