cookie
02-06-2007, 03:06 PM
I have an antique picture for a church that is 45 by 78 by 1.5 deep with arched sides that come to a point at the top like old church windows. I traced around it on cardboard and laid that on the bot and used the bot to get points to go to pw2. I drew one side and then used 3/16 offset to the outside of the picture to get a space for installation of picture then made another offset to a 3" frame. so far so good. this was the back portion of the frame. I then took my original line and made an offset to the inside of 3/4" and outside of 2". I then made a copy fo the top portion and laid it on the back portion and the curves do not match. Help? thanks Bruce