Tool Database Error in SB3 Preview

[jdervin]

My SB Starter Set came with a 1" x 60° V-bit (37-82) and Onsrud describes the 37-82 as 1", but the tool database in SB3's Preview Mode lists the same bit as a 1/2" diameter instead. I think this might be an error. Fortunately, it can be edited, but edits are lost when upgrading. I am hoping that the fine folks at ShopBot might look into this for the next release of the control software.

As of this post, I am using version 3.6.14

[srwtlc]

John, If you save a copy of your tool database (C:\Program Files\ShopBot\ShopBot 3\Previewer\ToolDatabase\tools.tool_db), you can replace it after an update. If you have your tool database for Aspire/VCP/PartWorks customized, you can use that one too. That way, all your tool databases match up.