MasterCam Post for Shopbot with 2 Z Axis

[kmeicho]

My computer recently had to be repaired and all my post processor setups for mastercam were erased. I had foolishly not backed up them with my other files. At one time there was a post for a 2 Z axis shopbot set up such as mine. I would like to somehow get a copy. Can anyone help me out with this?

[stevel]

There was a second one on the software and drivers page but it is no longer there. The one I did for a single Z axis is still there. You may want to contact the kind folks at Shopbot to see if they have an old copy of the other one.
Steve