joe@hcitables.com
05-29-2004, 09:58 AM
After setting up my SB, I chose to move to move the control box and PC to the other side. I now stand at the 96,48 corner when operating the PC.
While not a huge problem, I'd much prefer to be at 0,0. Is there a way to rotate the table 180d (as far as the software is concerned) without physicaly doing so? Seems like there would be a setting that move the motors in the oposite direction, then I'd just rezero the table in the diagonaly oposite corner but I can't find it. If I do this, would the default C3 (zero on lim switches) need to be modified or would it reflect the changes?
Thanks,
J
While not a huge problem, I'd much prefer to be at 0,0. Is there a way to rotate the table 180d (as far as the software is concerned) without physicaly doing so? Seems like there would be a setting that move the motors in the oposite direction, then I'd just rezero the table in the diagonaly oposite corner but I can't find it. If I do this, would the default C3 (zero on lim switches) need to be modified or would it reflect the changes?
Thanks,
J