bleeth
01-25-2009, 04:16 PM
It has been so long since I have needed to do this that the system has apparently changed.
Lets say that I have a file that I want to run first from table 0,0 and then from 3,0 and then from 6,0. The way that it was done many moons ago isn't working and I have not been able to get it to work in preview. The object file is being created in Artcam and I removed the commands such as go back to 0,0, SO,s etc. but it still insists in not running correctly. Can someone post the subroutine file for the example above or similar that I can adapt to my genuine needs? Thanks
Dave
Lets say that I have a file that I want to run first from table 0,0 and then from 3,0 and then from 6,0. The way that it was done many moons ago isn't working and I have not been able to get it to work in preview. The object file is being created in Artcam and I removed the commands such as go back to 0,0, SO,s etc. but it still insists in not running correctly. Can someone post the subroutine file for the example above or similar that I can adapt to my genuine needs? Thanks
Dave