knight_toolworks
02-06-2008, 07:15 PM
I made this in vcarve. I drew one of the corners then did a circular array copy then a join vectors to make the square. I did a offset to get lip around the inside.
I copied it for the second one and then saved it as top and bottom to have the separate files.
I cut them out from the bottom using a tapered endmill. One side is perfect the opposite has a uneven band. I checked the drawing and all looks fine.
here is link tho the pic thats larger and easy to see http://s154.photobucket.com/albums/s266/knighttoolworks/?action=view&current=upload.jpg
the lip is off on one side you can see it is wide on both of them. I have no clue how this can happen. fine on one side off on the other even though both sides were the same file.
I have the files if you want me to send them to you.
4539
4540
4541
4542
I copied it for the second one and then saved it as top and bottom to have the separate files.
I cut them out from the bottom using a tapered endmill. One side is perfect the opposite has a uneven band. I checked the drawing and all looks fine.
here is link tho the pic thats larger and easy to see http://s154.photobucket.com/albums/s266/knighttoolworks/?action=view&current=upload.jpg
the lip is off on one side you can see it is wide on both of them. I have no clue how this can happen. fine on one side off on the other even though both sides were the same file.
I have the files if you want me to send them to you.
4539
4540
4541
4542