Arcs or No Arcs for post

[procarve]

Does anyone have any performace experience with using the arcs post vs the no arcs post for a PRS tool (new model).

If this has been discussed previously a link to the thread would be great... I can't seem to find a discussion about it.

Thanks,

Bill

[Brady Watson]

Cutting speed (efficiency) and quality are better with the arcs post than the straight segment (regular) post. Always use the Arcs post unless you need readibility for programming (sans the CG commands).

-B

[procarve]

Thanks Brady - (and Bill via email)

That's what I was thinking but thought I would ask.

Machine is running great.