Profiling problem

[Kstrout@snet.net]

I am trying to cut out the profile of an object that I created. I choose profile as my toolpath, I choose all my options and click on calculate. It opens up the offsetting contours box then closes with no errors, but it doesn't cut anything when I try to cut it out.

[bjwat@comcast.net]

Ken,
Did you open up the .sbp file and look at what is in there using Wordpad?

-Brady

[Ken Strout]

I did but I don't really know what I am looking at.

[bjwat@comcast.net]

E-mail it to me and I'll see if I can figure it out.

bjwat@comcast.net (mailto:bjwat@comcast.net)

Are you sure that you weren't in 'Preview' mode? Do all other files cut ok?

Let me know.

Brady

[Kstrout@snet.net]

I wasn't in Preview Mode, but one thing I did notice is after it calculates the contours it doesn't put a line around the outside edge like it normally does in Part wizard.

[bjwat@comcast.net]

Did you select the contour before you ran a toolpath? Seems like it's something simple...

[Ken Strout]

It seems like it is always something simple. I will send the file to you see if you can figure it out.

[bjwat@comcast.net]

Did you get my e-mail?

[Ken Strout]

Brady
Thanks for the Help it turns out the problem was with the ends of the file. The points on the design were to sharp for a router to cut them out so I just rounded the points and it is all set.