Can you flip a part on V-Carve???

[maginter]

Hi Guys -

I have situation that I would like to make some horizontial cuts on one side and vertical cuts on the other. Is there a way to show this in the Toolpath preview? I am assuming the answer is no, but I thought that I would ask.

TIA,

Mark

[mark_m]

Hello Mark,

You will not be able to preview both sides at the same time I am afraid.
The best that you could probably do, is put your vectors
on to different layers, for clarity.
Create two separate toolpaths (or sets of toolpaths).
Use the "Preview Toolpath" to display the one side, then "Reset Preview" to clear the view.
Then use the "Preview Toolpath" to display the other.

I hope that this helps.

Mark.