Using the 3D Spiral Strategy

[magic]

Concerning: Using the 3D Spiral strategy.

How do you make the bit cut from the center of the material and spiral outward?

[bleeth]

Check the "selected vector" box, than "Offset" strategy. You will see the option for starting on the inside or outside pop up. If you wish to machine the entire model, just draw a boundary vector.

[magic]

Wow... you are good

[bleeth]

Just experienced

[knight_toolworks]

I wish cut3d had that option. had to turn down a job where going back and forth for this angle just sucked. around and around would have been perfect.