changrudy
09-15-2009, 09:22 PM
Hi,
I've just made my first 2d carving and had noticed the part was offset by about 0.25, 0.25. I realized the offset is there in the preview of the control software. My question is, is there a relation to the material parameters in the control software preview and the actual .sbp file? I would think if the partworks file is centered, load the file and cut, it would remain centered.
The bottom left hand of my part was made 0,0.
Thanks,
Rudy
I've just made my first 2d carving and had noticed the part was offset by about 0.25, 0.25. I realized the offset is there in the preview of the control software. My question is, is there a relation to the material parameters in the control software preview and the actual .sbp file? I would think if the partworks file is centered, load the file and cut, it would remain centered.
The bottom left hand of my part was made 0,0.
Thanks,
Rudy