danburk
05-19-2001, 12:51 AM
I was wondering; does anyone know of a ¼-sanding drum that can be used on the PC at 10K RPM.
After finishing my cuts I would like to sand the sides before I remove the tabs.
Thanks in advanced.
I just purchased a used ShopBot last week and have it all setup and cutting parts. This thing is great.
Dan Burkhardt
Signs of Wood, Co.
http://www.signmakershop.com
After finishing my cuts I would like to sand the sides before I remove the tabs.
Thanks in advanced.
I just purchased a used ShopBot last week and have it all setup and cutting parts. This thing is great.
Dan Burkhardt
Signs of Wood, Co.
http://www.signmakershop.com