View Full Version : Real Use Feed ,Speed settings
scott
01-11-2002, 04:03 AM
Need Info. for cutting 3/4" melamine w/p.b. core and 3/4" mdf boards. Suggestions about tooling used,depth of cut per pass would also be helpful.
shuttle
01-14-2002, 01:39 PM
It works fine at 2in/sec on 3/4 mdf with a 1/4 spiral carbide bit.
shuttle
01-14-2002, 01:40 PM
That is 1 pass to cut btw.
scott
01-14-2002, 07:32 PM
thanks Rob. Can you tell me what speed the router or spindle is?
shuttle
01-14-2002, 11:32 PM
Its a Makita RF1100, at full speed, 24,000RPM
It makes a heck of a noise in the process, and
that is quite fast, so be prepared.
jrdawe@bellsouth.net
02-12-2002, 03:46 PM
Shuttle,
I must ask you. Are you a carbide bit salesman? I read your cutter feed rate information and used a spiral 1/4" onsrud bit. I have a colombo 5 hp hf spindle set at 24000 rpm. Snapped that bit like a toothpick @ 1.75 ips. Please explain.
Best regards,
John
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.