davidp
12-14-2007, 07:30 PM
Hi all,
I have a job coming up cutting 135mm dia (5 1/2") circles from 15mm (5/8") PVC. The part also has 5mm holes drilled approx 12mm in from outer edge and an inner profile as well.
My question is what chipload should I be looking at to achieve a smooth cut.
What strategies have others used cutting PVC. Any assistance or advice on do's and dont's would be appreciated.
Regards,
David.
I have a job coming up cutting 135mm dia (5 1/2") circles from 15mm (5/8") PVC. The part also has 5mm holes drilled approx 12mm in from outer edge and an inner profile as well.
My question is what chipload should I be looking at to achieve a smooth cut.
What strategies have others used cutting PVC. Any assistance or advice on do's and dont's would be appreciated.
Regards,
David.