pete
09-17-2009, 05:43 PM
Can anyone advise if a steel table for a PRT Alpha (Aluminum "Y" struts) will work for an older PRT (U-Channel "Y" struts)?
What about the "X" rack interfacing with the older pinon gears?
Could someone with an older PRT measure the "X" rails center-to-center - is it 66.250"?
Thanks
What about the "X" rack interfacing with the older pinon gears?
Could someone with an older PRT measure the "X" rails center-to-center - is it 66.250"?
Thanks