btkfrisco
01-04-2009, 04:43 PM
I use Alibre Design to draw my parts. I can export an .STL file for these parts. It cuts nicely on the Buddy32...
Now, I'd like to be more efficient. I'd like to take multiple parts designed in my Alibre software and cut them on the same sheet of material. However, I cannot figure out how to do this in PartWorks3D.
Any help would be appreciated!
Brian
Now, I'd like to be more efficient. I'd like to take multiple parts designed in my Alibre software and cut them on the same sheet of material. However, I cannot figure out how to do this in PartWorks3D.
Any help would be appreciated!
Brian