beacon14
06-14-2001, 06:36 PM
Correct me if I am wrong, but it seems that if you insert a FP,(FILENAME) command in a part file, then run the file using 2D offset, the 2D offset is not applied to the nested file.
I suppose you could program the router to move back to the beginning point from which the main program was started, then add the 2D offset to the FP command parameters. Is there an easier way?
I suppose you could program the router to move back to the beginning point from which the main program was started, then add the 2D offset to the FP command parameters. Is there an easier way?