Nesting

[jrw00d2@aol.com]

I have a new prt96 and I am using a imaging program to carve photos, How do I get the machine to 1, carve multiple copies of that file across the table and 2,cut multiple files instead of 1 at a time. I have looked into the editer, but because of the file sizes it will only let me look at the first 69,000 lines, some of these are 150k plus.
Any ideas
Thanks
Jay W.

[davidallen]

doesn't the FP command allow multiple cuts with an X offset? you may need to convert to relative rather than absolute moves.

[jorgy.tucson@worldnet.att.net]

Add a short program at the end of your photo file to move tool to start of next photo. Reset your zero points so you can stay in absolute. Use record and replay commands to execute file at new location.
John J.