bahed
04-12-2008, 11:54 AM
I have an undersized spring set holding up my Colombo Spindle. Following upgrading to the current 3.58 control software last night, which included the step where you turn your control box off for 30 seconds while the drivers get updated (this is where my spindle very slowly descends - because the springs aren't strong - enough until something stops it, which was my SB Probe against the wood vac board !!), I now have an unresponsive probe.
It was working perfectly fine yesterday morning, but now I get the following error message when I use the Copy-Machine utility as soon as I hit the 'Copy' button:
Run-Time error 13
Type Mismatch
Thoughts ?
Bret
It was working perfectly fine yesterday morning, but now I get the following error message when I use the Copy-Machine utility as soon as I hit the 'Copy' button:
Run-Time error 13
Type Mismatch
Thoughts ?
Bret