johnm
09-27-2005, 06:10 PM
Hello All (or "Folks", if you prefer) -
I emailed Wayne Locke regarding his Harbor Freight Lathe/Indexer set up for specifics on which model lathe he used, rails and all the nitty gritty, but haven't heard back, so I don't know if his contact info is still valid.
Do any of you have a set up for an indexer/lathe similar to his configuration? I don't really need to have a stepper hooked up just yet, being able to do straight turnings would be enough of a challenge in getting started.
We are going to be ordering a 5x8 SB very shortly and would like to configure the machine so that we can do turnings from the get-go. We will modify the locally fabbed table to work with a long lathe bed.
If any of you have specifics, I would sure appreciate hearing from you.
Thanks!
John Moorhead
Lakeport, CA
I emailed Wayne Locke regarding his Harbor Freight Lathe/Indexer set up for specifics on which model lathe he used, rails and all the nitty gritty, but haven't heard back, so I don't know if his contact info is still valid.
Do any of you have a set up for an indexer/lathe similar to his configuration? I don't really need to have a stepper hooked up just yet, being able to do straight turnings would be enough of a challenge in getting started.
We are going to be ordering a 5x8 SB very shortly and would like to configure the machine so that we can do turnings from the get-go. We will modify the locally fabbed table to work with a long lathe bed.
If any of you have specifics, I would sure appreciate hearing from you.
Thanks!
John Moorhead
Lakeport, CA