View Full Version : Ogee Cutter Bits
shawnn82
01-12-2010, 04:10 PM
I am trying to make my sign borders a little more decorative and have been lookin into using ogee bits on my shopbot. A lot of them I have found to have the guide bearing on the end. Is there any place I can get them relatively cheap without the bearing? I am open to all ideas or suggestions. Other than cutting off the bearing is there a workaround to this?
billp
01-12-2010, 04:27 PM
http://www.eagleamerica.com/prod_detail_list/s
http://www.eagleamerica.com/product/vp13-2307/pc_-_groove_forming
By combining a few different profiles, you can make an endless numbers of borders...
bryson
01-12-2010, 04:28 PM
Shawn, Check out Magnate. They have bits that go to a point and are reasonably priced.
myxpykalix
01-12-2010, 05:05 PM
www.magnate.net (http://www.magnate.net) not .com
http://magnate.net/index.cfm?event=showProductGroup&theID=192
ghostcreek
01-13-2010, 12:07 PM
Most all suppliers have what they call "Plunge Bits". Made for a plunge router (I believe), these have no bearings. Do a search for these and you will be able to create pretty much whatever you want. Remember, sometimes using two profile bits you can come up with some awesome profiles.
shawnn82
01-14-2010, 03:54 PM
Thanks guys, that was exactly what i was looking for!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.