maginter
07-01-2008, 08:24 PM
Hi Guys -
I have looked throught the archieves and haven't found anything so I thought that I would ask.
I am going to cut Excell White PVC, 3/4". I know about the speeds, and to use a upcut with a clean out cut. However I have not found any details on the Super O or the Spiral O, only some suggestions. So which do you guys prefer and do you have a good source to order them from???
Thanks,
Mark
I have looked throught the archieves and haven't found anything so I thought that I would ask.
I am going to cut Excell White PVC, 3/4". I know about the speeds, and to use a upcut with a clean out cut. However I have not found any details on the Super O or the Spiral O, only some suggestions. So which do you guys prefer and do you have a good source to order them from???
Thanks,
Mark