bill_lumley
06-19-2009, 07:51 PM
I discovered I have a problem where my air drill will not cover the entire X length . It falls short about 5" from the end of the table . I can attribute that to where I mounted the legs on my table. It means I have my table offset where it should be . I attribute this to the lack of clarity in the installation manual and I have been living with it till now. Before I get aroung to tearing my table down I need to get a job done and that means I will have to leave some sheets till the end and juggle parts to avoid hitting the 'dead spot' on my table .
Question is when I have my TWD file loaded and nested it shows selectable sheets . It gives the appearance you can cut any sheet in any order but when you say 'write to Shopbot' it appears to calculate every sheet again . Is this a red herring and it really will cut the sheet shown in the nest diagram ?
Thanks Bill
Question is when I have my TWD file loaded and nested it shows selectable sheets . It gives the appearance you can cut any sheet in any order but when you say 'write to Shopbot' it appears to calculate every sheet again . Is this a red herring and it really will cut the sheet shown in the nest diagram ?
Thanks Bill