jbworden
07-22-2009, 06:09 PM
I just got around to connecting the proximity switches that came with my PRS Standard. (Hey. It's only been 4 years. What's the hurry?) Since my control board doesn't match the manual I scrounged around here on the forum and finally found a diagram that more closely matches my setup. Problem is that while one of the switches works great the other shows a red light on the switch itself and a yellow light on the monitor. Of course any attempt to use the bot gives me a limit switch error. What might I have done wrong?
My switches have black, red, and green wires instead of the black, brown and blue shown in the diagram. I connected both greens to Input GND; both reds to Output +12, and the blacks to Input 2 and 3 (one each).
Any ideas what I have done wrong?
My switches have black, red, and green wires instead of the black, brown and blue shown in the diagram. I connected both greens to Input GND; both reds to Output +12, and the blacks to Input 2 and 3 (one each).
Any ideas what I have done wrong?