From Patrick @ Acrylic Designs in Phx

[acrylman]

Hello All, just purchased a used shopbot. I am well experienced in acrylics but know nothing about cncs, can anyone advise me on a good place to start? software classes? books?
thanks

[beacon14]

Patrick,

Look into the training classes held monthly at ShopBot in Duram, NC. That's the best way to get hands-on training that's geared specifically to the ShopBot.

Read everything you can on this forum.

Attend any of the informal Camps that are held periodically around the country.

Then, if you have specific questions, ask them here!

Welcome to the "family"

David B.

[paco]

This forum; perform some search with keywords that come to you easily...
and...
http://www.plasticrouting.com/

That could be a start. Good luck!

[acrylman]

thanks I will check them out. Please let me know if there are any camps in the west(AZ CA NV)
thanks